PnP is activated only for the initial setup on Day 0 Policy Infrastructure Controller Enterprise Module (APIC-EM) server. Using the Cisco Network Plug and Play (PnP) solution, you can provision the primary AP automatically via a remote Cisco Application Using the CLI Initial Configuration Wizard.Īuto-provisioning the Primary AP via Cisco Plug and Play Universal AP Priming and Cisco AirProvision User Guide, at this URL:Īfter these prerequisites are met, proceed to Configuring the Switch Port.Ĭonfiguration Wizard is also available, but recommended only for advanced Using universal regulatory domain access points, then you will need prime theĪccess point to the right regulatory domain, before the APs start serving Mobility Express wireless controller web interface and the initial For a list of browsers compatible with the Cisco You cannot access this SSID through a wired network. You require a Wi-Fi-enabled laptop to connect to the pre-defined CiscoAirProvision SSID advertised by the primary AP. Of the Cisco Mobility Express controller can be done only through theĬontroller configuration wizard and over Wi-Fi. This DHCP server for IP address management of the access points and the To use an external DHCP server instead, then ensure that a DHCP server is Optionally setup during the initial configuration wizard. This will ensure that the pre-defined CiscoAirProvision Service Set Identifier (SSID) is advertised only by the primary AP and not by other APs.Ĭisco Mobility Express provides an internal DHCP server which can be This is to ensure that this AP can act as the primary AP, and the other APs can The first AP to be set up should be one that supports the Cisco MobilityĮxpress wireless controller functionality. Other than the Cisco Mobility Express controller, in the network.ĭecide on the first access point (AP) to be set up.

Ensure that there no wireless controllers, Network, during setup or during daily operation of a Cisco Mobility ExpressĮxpress controller cannot interoperate or co-exist with other wirelessĬontrollers in the same network. Other Cisco wireless controllers, neither appliance nor virtual, in the same Setting Up and Accessing Cisco Mobility Express Understanding the Mobility Express Controller Web Interface.Preparing APs to Associate with the Primary AP.Converting from CAPWAP Lightweight AP to Cisco Mobility Express Software.Checking if an AP has CAPWAP Lightweight AP Software or Cisco Mobility Express Software.Starting the Initial Configuration Wizard.Auto-provisioning the Primary AP via Cisco Plug and Play.Prerequisites for Setting Up and Accessing Cisco Mobility Express.

Cisco connect setup software for mac